New Slabs · SLC Epoxy Flooring
New Concrete Garage Floor Slabs in Salt Lake City, UT
Cracked or sunken garage slabs replaced and poured with a future coating in mind. Get a free quote.
Salt Lake City, Holladay, Murray, Sandy, South Jordan, Herriman, Lehi, Orem and 28 more

Free Garage Slab Quote
Add the garage or shop size, the slab's age if you know it, and any cracks, stains or old coatings. Expect a callback about the floor and a time to see it.
- Free floor quotes
- Diamond-ground prep
- Moisture tested
- Solid or flake systems
Car count or rough square footage is plenty.
New Garage Floor Slabs
Concrete Garage Floor in Salt Lake City, UT
Some garage floors are past coating. A slab that has sunk at the door, heaved in the middle, broken into pieces or scaled down to loose stone will carry those problems straight through anything applied on top. Around the Salt Lake Valley the usual causes are fill beside the foundation that kept settling, lake-bed clay reacting to water, and years of salty slush freezing on a slab that was never sealed. Replacing the slab fixes the base and gives you a clean starting point for a coated floor.
A garage slab poured with coating in mind differs a little from a standard one. A vapor barrier under the concrete keeps ground moisture from pushing on a future coating. The floor falls gently toward the door so meltwater drains out, the surface gets a smooth trowel finish that grinds evenly, and control joints are laid out where they will be easy to treat. Typical garage slabs are about 4 inches thick on compacted gravel, heavier where trucks or a camper will park, and coating waits roughly a month while the concrete cures.

What's included
What goes into new garage floor slabs
- 01
Tear-out and haul-off
The old slab is broken up and hauled away, with care around the foundation walls and the door.
- 02
Base rebuild
Soft soil and settled fill are dug out, and gravel is placed and compacted in lifts.
- 03
Vapor barrier
A sheet barrier under the slab to keep ground moisture away from a future coating.
- 04
Reinforcement
Rebar or welded wire mesh held up on chairs in the middle of the slab.
- 05
Slope to the door
A gentle fall toward the garage door so snowmelt and wash water run out instead of pooling.
- 06
Coating-ready finish
A smooth trowel finish and a joint layout planned for grinding and coating later.
Examples
New Garage Floor Slabs: examples of the work
Stock photos: examples of the work type.
How it works
New Garage Floor Slabs, step by step
- 1
Measure and plan
We check the old slab, why it failed, access for equipment and what will park on the new floor.
- 2
Remove and rebuild
Old concrete comes out, the subgrade is repaired, and the base and vapor barrier go in.
- 3
Pour and joint
Concrete is placed over reinforcement, finished, and jointed at the planned spacing.
- 4
Cure, then coat
Cars can usually return after about a week, and a coating follows once the slab has cured and tests dry.
Questions
New Garage Floor Slabs questions
Why do garage floors sink near the door in Utah?
The soil there is often fill placed against the foundation that settled after the slab was poured, and meltwater entering at the door softens it further. Where the ground is old lake clay, its swelling and shrinking add to the trouble. A new slab needs that fill dug out and replaced with compacted gravel.
What does a new garage floor slab cost?
Size, how hard the old slab is to remove, how much base needs rebuilding, thickness and access set the price. A tight garage with a low door can limit equipment and add labor. Quotes are free and follow a look at the garage.
Does replacing a garage slab need a permit?
It depends on your city and the scope. A straight replacement inside an existing garage sometimes doesn't, while a new garage or a slab tied to structural work typically does. Any digging starts with an 811 call, and a new driveway approach in the street right-of-way needs a city permit.
Should a new garage slab have a vapor barrier?
If you might coat it someday, yes. Without one, moisture from the ground can rise through the concrete and push on a coating from below, which is a common reason coatings blister on older slabs.
How long before a new slab can be coated?
About 28 days at minimum, and longer in cool weather. The concrete has to gain strength and dry down enough to pass a moisture test, or the coating may not grip.
Coatings and concrete
More from SLC Epoxy Flooring

Epoxy Garage Floors
Solid-color garage coatings over a diamond-ground, crack-repaired slab, finished with a UV-stable clear topcoat.
More on epoxy garage floors
Shop & Workshop Floors
Heavier-build coatings for workshops and work bays that see jack stands, rolling toolboxes, solvents and spills.
More on shop & workshop floors
Concrete Sealing
Penetrating sealers for driveway aprons and walks, topical sealers for garages and patios, matched to each slab's use.
More on concrete sealing
Service area
New Garage Floor Slabs in these towns
We quote new garage floor slabs for homes and shops in these towns:
Salt Lake County
Tooele County

Free quotes on new garage floor slabs
Send the garage size and what's on the floor now, and a free quote follows with the prep explained.





